Car Oil Change Tips And Tricks: When And How
Everyone loves the car they drive, but it is important that the car not only looks good on the outside but also has a clean and efficient engine on the inside. There is no better way to maintain the efficiency of your car’s engine than to change the oil regularly. Over time, as you continue to drive, the oil will disintegrate and change color, and driving will not feel smooth enough. In addition to the oil, you should also change the filter regularly because it is blocked by contaminants.
The oil change time depends on the type and use of the vehicle, but fortunately, they are not expensive, so it is best to do it regularly when necessary.
Another misconception that people have is that changing the oil is a big problem and that they need someone’s help to do it. We share some tips and tricks so you can do it yourself and try to save some money.
Oil Lifting And Draining
Begin by lifting your car up so that it is easier to move under it. Don’t forget to put on the jack stand after you lift your car, this is very important for your safety.
Another step is to drain the old oil. Some people skip this step to save time, but it is very important to remove the old oil. Remember that the oil should not be too hot or too cold, it should only be warm. If you just got in from driving, let the car rest for a while. Likewise, if the car has not been running for a long time, just start the engine for a few minutes to warm up the oil.
In the front of the car, you will find the oil stud under the car engine. Place the drain tray under the latch. Unscrew the screw with the right socket, and the oil will begin to flow into the pan. Don’t forget to remove the oil cap on the top of the engine as it will help the oil drain quickly. Wait a few minutes for the oil to dry completely because it is a thick liquid. When the oil stops coming out, you can reinstall the latch in the same place.
Change the Oil in Your Car in 6 Simple Steps
- Buy the right oil and oil filter
While Removing the oil filter take out the old oil filter and make sure that the rubber gasket comes with it. If not, remove it from the engine.
- Oil filter switches
Different oil filter wrenches work best for different cars. Decide which one gives you the most wiggle room.
- Add fresh oil
Refill the motor with a funnel and repack the bottle (to prevent spills) before putting it in the recycling bin.
- Recycle old oil
Pour the used oil into a large jug. Fill the engine and let it run until the oil light on the dashboard goes out. Wait a few minutes, then check the dipstick and add oil if necessary.
Tips
If the engine is cold, start it and let it run for five minutes to warm up the oil. If it’s hot, wait at least 30 minutes to avoid burning yourself.
Never use an adjustable wrench or socket in a drain plug. Use a box wrench of the appropriate size, usually metric, for the socket. Always use sling holders. Never operate under a vehicle that is supported by a jack only. it may seem like a money saver, an inexpensive oil filter is usually only good for about 3,000 miles. To extend the life of your oil, use better quality filters if you travel more than 3,000 miles between oil changes.
- Pull the Oil Plug
Then drive your car over it. This will take the work out of cleaning up oil spills, as you can throw the entire sheet away when you’re done, or save it for the next change if you’re lucky enough not to spill. Lift the car, put the jack stands in place and lower the car. Unscrew and quickly remove the plug from the oil stream. Clean the drain plug and install a new gasket (if necessary).
Summary
Here get all information regarding, better way to maintain the efficiency of your car's engine than to change the oil regularly
Source
https://scrapcarsremovalsydney.com.au/
Leave a Reply
You must be logged in to post a comment.